The PicoSSR is the one of the smallest MOSFETs on the market that is meant for electric airsoft guns. The measurements are 4×6×18 mm and it is an updated version of its predecessor PicoSSR 2. The PicoSSR 3 is so small that you can install it inside the gearbox! The unit's mechanical and electronic features are significantly more advanced than in previous models. It withstands submerging into water (manufacturer guarantee). It can be installed into most electric airsoft guns, including the most powerful (M170) DMR rifles. The unit's operating voltage range for the battery is 7.2 V – 12.8 V.
voltage range for the batteries 7.2 V – 12.8 V
easy to install – you need only to install the signal wire and change the old connections with conductor surfaces
The package includes:
GATE PicoSSR 3 unit
Two signal wires (60cm)
Three heat-shrink tubings to protect the conductor.
MOSFET (Metal Oxide Semiconductor Field Effect Transistor)
The unit reduces power loss due to normal mechanical contact in the trigger switch. When using MOSFET only the signal current flows through the trigger switch and the actual running current goes directly from the battery to the motor. This prevents the burning of the trigger contacts, which is going to happen sooner or later, especially when using powerful batteries – the average lifetime for contact surfaces in an actively used gun is around one year. At the same time, the MOSFET unit enables the maximum power flow in the circuit without unnecessary resistance due to worn trigger contacts. This also gives you a higher rate of fire and a faster trigger response.
24 month warranty
GATE MOSFETs have an extended two-year warranty. It covers manufacturing defects and problems that come up in normal use. The warranty does not cover any fault that is caused by a faulty installation or misuse, like one caused by too high a voltage. You have to use a separate fuse, which protects the MOSFET from short circuits especially with more powerful LiPo batteries, when using NanoASR, -AAB and PicoAAB MOSFETs or SSR series MOSFETs which do not have an electronic fuse. The use of a separate fuse in other MOSFETs is recommended. You will find installation instructions on GATE's website or in Tradetech.